MobilePartners 3G panel antenna 17dBi with 10 m cable

Article no.: MP17P
Delivery time: Est. delivery 7d

17dBi high gain directional antenna for the 3G band Specially developed as a donor antenna for 3G repeaters. It has a whopping 17 dBi gain and an opening angle of only 15 degrees both vertically and horizontally . This makes the large antenna the first choice for all 3Grepeater i... read more

799 kr

button_wishlist

17dBi high gain directional antenna for the 3G band

Specially developed as a donor antenna for 3G repeaters.

It has a whopping 17 dBi gain and an opening angle of only 15 degrees both vertically and horizontally . This makes the large antenna the first choice for all 3Grepeater installations.

The narrow opening angle means that it only communicates with one base station and reduces crosstalk and load on other base stations.

The very high gain factor makes it also suitable for places where you have poor reception even outdoors.

The antenna is made to be mounted on a pole. For wall mounting, for example, a small parabola bracket for the wall is recommended.

Supplied with 10 meters of cable with N-male at one end and SMA male at the other end.
Adapter for SMA to N-male is also included to be able to connect to a MobilePartners MP2110A 3G repeater.

Antennas for 3G repeaters

Förstärkning	17 dBi
Frekvensband	1910-2170 MHz
Impedans	50 Ohm
Fäste	Maströrsfäste
Placering	Utomhus
Storlek	37 x 37 cm
Anslutningar	N-hona
Antennsladd	10 meter (lös kabel) med N-hane + SMA hane. Adapter SMA-hona till N-Hane ingår
Öppningsvinkel	15 grader

Förstärkning	17 dBi
Frekvensband	1910-2170 MHz
Impedans	50 Ohm
Fäste	Maströrsfäste
Placering	Utomhus
Storlek	37 x 37 cm
Anslutningar	N-hona
Antennsladd	10 meter (lös kabel) med N-hane + SMA hane. Adapter SMA-hona till N-Hane ingår
Öppningsvinkel	15 grader

Explanation of frequency bands

When choosing an antenna, pay attention to which frequency bands the antenna supports. Depending on which operator and where the antenna will be used, the frequency bands vary. Larger cities use 2600MHz while smaller towns use 800/900MHz with some support bands in between such as 1800/2100MHz.

A higher frequency band gives a higher speed but also has a shorter range. The same applies to the antenna, if you have a base station that transmits on 2600MHz, your antenna, antenna cable and the location of the antenna become more important than on a lower frequency band. Explanation of signal loss we will go through soon. Higher frequency bands also mean shorter range from the base station.

450MHz (coverage band) also known as the Net1 band is the frequency band that covers the most area in Sweden. Therefore, Net1 is known to be able to have reception where other operators don´t have a chance, but with low download and upload speeds. The reason why this band is called Net1 is because that the company Net1 has exclusive rights to this frequency band.

800MHz (coverage band) is used by all common operators, excluding Net1. The low frequency band means that 800MHz covers a lot of space. Therefore, the band is used outside big cities or smaller towns. 800MHz is the most used frequency band around Europe.

900MHz (coverage band) is the band that Tele2 and Telenor initially used as coverage band. 900MHz is a more unusual LTE band and in the beginning the band caused some problems when the clients (mobile phones etc.) could not connect to 900MHz. Today, the mobile phone manufacturers have adapted the mobile phones to be able to communicate on 900MHz.

1800MHz (capacity band) is the latest frequency band launched. All operators today use this band in metropolitan centers (apart from Net1).

2600MHz (capacity band) is a very well-used frequency band all over Europe. 2600MHz is the highest frequency band used for LTE, this means that the band also has the shortest range compared to 800/900MHz. Due to the high capacity, the band is used in metropolitan environments where many base stations are required to cover as much surface as possible and have as high a capacity as possible.

Frekvensplan 4G