The Poynting XPOL-1-5G 4x4 MIMO is the second generation V2 of the very popular XPOL 2×2 MIMO antenna.
The antenna has been completely redesigned from the previous generation with a completely new housing and antenna design. The antenna now includes the newer 3400-3800 MHz ba... read more
The Poynting XPOL-1-5G 4x4 MIMO is the second generation V2 of the very popular XPOL 2×2 MIMO antenna.
The antenna has been completely redesigned from the previous generation with a completely new housing and antenna design. The antenna now includes the newer 3400-3800 MHz bands, the lower 698 MHz band and is suitable for 2G/3G/4G and 5G.
This antenna works exceptionally well in the following frequency bands: 698-960 MHz . the performance of the antenna.
This makes the antenna perfect for most application areas, such as urban, rural and commercial, to achieve the best possible coverage over a large area.
The robust construction makes the antenna weatherproof -, dust and vandal resistant and provides an IP65 rating, suitable for harsh environments.
New 3400MHz-3800MHz, 5G band
Good performance over the primary 4G/ The 5G bands
Cross-polarized 4x4 MIMO antenna
Mounting on window, wall or pole
Robust construction, weatherproof and waterproof (IP65)
When choosing an antenna, pay attention to which frequency bands the antenna supports. Depending on which operator and where the antenna will be used, the frequency bands vary. Larger cities use 2600MHz while smaller towns use 800/900MHz with some support bands in between such as 1800/2100MHz.
A higher frequency band gives a higher speed but also has a shorter range. The same applies to the antenna, if you have a base station that transmits on 2600MHz, your antenna, antenna cable and the location of the antenna become more important than on a lower frequency band. Explanation of signal loss we will go through soon. Higher frequency bands also mean shorter range from the base station.
450MHz (coverage band) also known as the Net1 band is the frequency band that covers the most area in Sweden. Therefore, Net1 is known to be able to have reception where other operators don´t have a chance, but with low download and upload speeds. The reason why this band is called Net1 is because that the company Net1 has exclusive rights to this frequency band.
800MHz (coverage band) is used by all common operators, excluding Net1. The low frequency band means that 800MHz covers a lot of space. Therefore, the band is used outside big cities or smaller towns. 800MHz is the most used frequency band around Europe.
900MHz (coverage band) is the band that Tele2 and Telenor initially used as coverage band. 900MHz is a more unusual LTE band and in the beginning the band caused some problems when the clients (mobile phones etc.) could not connect to 900MHz. Today, the mobile phone manufacturers have adapted the mobile phones to be able to communicate on 900MHz.
1800MHz (capacity band) is the latest frequency band launched. All operators today use this band in metropolitan centers (apart from Net1).
2600MHz (capacity band) is a very well-used frequency band all over Europe. 2600MHz is the highest frequency band used for LTE, this means that the band also has the shortest range compared to 800/900MHz. Due to the high capacity, the band is used in metropolitan environments where many base stations are required to cover as much surface as possible and have as high a capacity as possible.
Frekvensplan 4G
Frequency band
Net1
Tele2
Telia
Telenor
Tre
450MHz (Band 31)
800MHz (Band 20)
900MHz (Band 8)
1800MHz (Band 3)
2600MHz (Band 38)
Box 22067 702 03 Örebro
Radiatorvägen 7 702 27 Örebro
019 - 7070 360 Info@lohelectronics.se
The product is currently Out-of-Stock. Enter your email address below and we will notify you as soon as the product is available.
7st
