Here you put together your package to register your car to an A-Tractor. All the equipment required for an installation + accessories are here so that you can easily find the right one and not choose the wrong one just your car. This variant of the regulator is connected via the ... read more
På den här artikeln kan du plocka ihop ditt egna paket. Vi har handplockat den utrustningen som vi anser är mest lämplig till just den bilmodellen du ska bygga på.
Here you put together your package to register your car to an A-Tractor.
All the equipment required for an installation + accessories are here so that you can easily find the right one and not choose the wrong one just your car.
This variant of the regulator is connected via the CAN-BUS system instead of using a generator for speed and inductive sensor for speed sensing on the car.
---
Tip for you
Cable set. We have at least one or more ready-made cable sets to save you time when wiring down to the accelerator pedal connector. Take a look at what your car's gas pedal connector looks like and choose the right cable set above.
Wire seal. For the cable set, we recommend a wire seal - Coarse to easily seal the cable set so that the connector cannot be pulled out and restored to original. It is important before regbes. Wire seal - Rough can be found under "accessories".
Helukabel. If we do not have a ready-made cable set for your car/model, we recommend that you choose an 8-wire Helu cable or universal cable set to be able to more easily cut and solder in the car's original connector for the H-CAN box to receive the correct variable values from the car's gas pedal. 8-wire Helu cable or universal cable set can be found under the tab "accessories".
Mounting box is a matter of taste. We recommend the new model-adapted H-CAN box which is black "art no: 03-154". Otherwise the aluminum box is plan B for encapsulating the H-CAN. Mounting box is very important for regbes.
12V for H-CAN, we recommend using a "double fuse" to be able to take power from the car's fuse box. If you need a smaller double fuse plug for your fuse box, look under "accessories".
Sealing hose is also important. All installation cables from the H-CAN green contact terminal (from the mounting box) down to the pedal must be encased in steel hose or hydraulic hose. Plastic hoses are normally not approved by the reg inspection. Sealing hose and hose coupling are available under "accessories". NOTE: the new "black" H-CAN box does not need a hose connection.
2-wire twisted CAN-BUS cable is a recommended CAN-BUS cable for H-CAN to receive both rev signal and speed signal from the car's CAN-BUS network Signal CAN-Hö g & CAN-Low that H-CAN needs to get rev and speed signal is normally in the OBD connector or can be found in a cable tangle in the car. 2-wire twisted CAN-BUS cable can be found under "accessories". If you are not sure where CAN-High & CAN-Low are in your car, get in touch with us and we will help you further.
Easy to install, takes less time and has a smoother break!
Fler än 100st
